ANDOLITE - MR12, 12 Channel DMX Mains Relay Wall Pack (Three phase)
Three Phase, MCB, Isolator + RJ45 / Screw Terminals
DMX Mains relay switching system - 6, 12 or 24 channels.
All models are built into standard electrical cabinets with steel hinged lockable doors (glass doors to special order), the 6 and 12 output models are built into a (HxWxD) 500 x 400 x 150mm housing. The 24 output channel model (HxWxD) 600 x 600 x 200mm housing.
A wide range of options allow the customer to ‘customise’ their exact requirements, these include: Mains Supply: Single or 3 phase Supply Input Switch: Isolator or RCD.
Output Protection: Single Pole MCB, Neutral Switching MCB, RCBO, Techna or ABB manufacturer. Current selection (6A,10A,16A) on a per output channel. Arc Fault Detection Devices combined with RCBO (AFDD) can be offered to special order, price and manufacturer to be discussed.
DMX in & thru connectors: 2 sets of 3 way screw terminals (hardwired DMX), 2 x RJ45 sockets, 5 pin XLR connectors (1 x male + 1 x female), 3 pin XLR connectors (1 x male + 1 x female).
To avoid any chance of large surge currents being present when all circuits are selected to come on, each relay has a delay of 0.25 second at power on.
Individual control of each output via standard DMX Single pole MCB, Neutral Switching MCB, or RCBO
DMX Address Setting
The unit has two modes of DMX operation which are selected via the DMX Address dials. In standard DMX mode each output is independently controlled and the full range of a universe can be used with the unit. In DMX sense mode the unit waits until a valid stream of DMX is present before sequencing the outputs on. The unit will then sequence the outputs off again once the DMX stream has been lost after 10 minutes.
020 8659 2558
