Full Fat Audio - FFA 2004 Amplifier

Full Fat Audio - FFA 2004 Amplifier

The FFA-2004 has 4 channels with output up to 1000 W connected to a 2 Ohm load. It has the same thermal capacity and power supply components as used in the higher power models in the range the FFA-4004 and FFA-6004. This gives the FFA-2004 very high thermal capacity and increased reliability so is ideal for installation in very demanding installations. Audio performance is excellent and the punchy sound gives the impression of more power than specified.

Suitable Applications

Small full range loudspeaker for example 5"-10" + 1" driver compliment, smaller bass units 8" -10" drivers.

Public address systems of any kind – peripheral systems in larger installations. AV systems.

High power mid range and HF drivers in multi way installed sound or touring sound systems.

Smaller stage monitors bi amp or full range

Features at a glance

Exceptional sound quality

G2 DSP option

Mains power efficient and cool running

Rugged Tour class Aluminium construction

Light weight - 9 kg

FFA Class D PWM

High current switch mode power supply

Superb limiter

4 XLR analogue audio inputs

4 XLR parallel outputs.

Bi amp Neutrik® speakON outputs

Signal Link through

Neutrik® powerCON power input

PSU soft start

Hand built & designed in Hertfordshire, England

5 year factory warranty

Power Ratings - FFA - 2004 - 4 x 250W 8 Ohm load, 4 x 500W 4 Ohm load4 x 1000W 2 Ohm load

Gain - 32 dB

THD - THD Typical 0.03 4 Ohm 1kHz THD+N

Frequency Response - 20Hz - 20kHz +- 0.5dB

Controls - 40 Point Potentiometer per channel, power on switch

Indicators - signal green = -20dB, signal yellow = -3dB, red signal = clip, signal red protect = over current, low AC mains or 3 sec. mute on power up

Load Protection - DC on output, side chain TCA clip limiter circuit

Amplifier Protection - Short circuit, current overload, thermal shutdown, high frequency stability circuit

Audio Signal Inputs - Balanced Neutrik® Female XLR input connected Pin 1 - GND, Pin 2 - Hot +, Pin 3 - Cold - . XLR Male signal throughput each channel

Audio signal outputs - Neutrik® speakON each channel. Channels 1 and 3 output speakON utilises 2+ and 2- connection to allow use of 4 core loudspeaker cable for bi amp loudspeaker system for example stage monitor system

Power requirement - 1 x Neutrik® 20A powerCON connector 1 x 16A 230 VAC Circuit. Power range 185V-230VAC 120V (configured at factory)

System cooling - High CFM 80mm fan with proportional signal speed control. Rear to front airflow

Dimensions - 88mm Height x 483mm Width x 510mm Depth. Includes rear rack support. 19" rack mount enclosure

Weight - 9kg