Full Fat Audio - FFA 4004 Amplifier

Full Fat Audio - FFA 4004 Amplifier

FFA four channel amplifier

Full power delivery all channels driven simultaneously loaded 4 ohms. Very useful and versatile multimode amplifiers, suited for large scale touring point source or line array systems. Equally suited in less demanding bass applications. Very installation friendly and ideal for bi amp stage monitoring systems or multi point theatre installations. Proprietary high efficiency FFA Class D output stage coupled with high current switch mode supply enables high power delivery even in the harshest environmental conditions.

Suitable Applications:

Small full range loudspeaker for example 5"-10" + 1" driver compliment, smaller bass units 8" -10" drivers.

High power mid range and HF drivers in multi way installed sound or touring sound systems. Smaller stage monitors bi amp or full range

Features at a glance:

4 x 1000 Watts at 4 Ohms

Power efficient and cool running

Rugged Tour class Aluminium construction

Light weight - 10 kg

FFA Class D technology

High current switch mode power supply

Side chain TCA clip limiter

Hand built and designed in England

Bi amp Neutrik® speakON outputs

Signal Link through

Neutrik® powerCON power input

PSU soft start

5 year factory warranty

Power ratings - FFA - 4004 - 4 x 600W 8 Ohm load, 4 x 1000W 4 Ohm load

Gain - 32 dB

THD - THD Typical 0.05 4 Ohm 1kHz THD+N

Frequency Response - 20Hz - 20kHz +- 0.5dB

Controls - 40 Point Potentiometer per channel, power on switch

Indicators - signal green = -20dB, signal yellow = -3dB, red signal = clip, signal red protect = over current, low AC mains or 3 sec. mute on power up

Load Protection - DC on output, side chain TCA clip limiter circuit

Amplifier Protection - Short circuit, current overload, thermal shutdown, high frequency stability circuit

Audio Signal Inputs - Balanced Neutrik® Female XLR input connected Pin 1 - GND, Pin 2 - Hot +, Pin 3 - Cold - . XLR Male signal throughput each channel

Audio Signal Outputs - Neutrik® speakON each channel. Channels 1 and 3 output speakON utilises 2+ and 2- connection to allow use of 4 core loudspeaker cable for bi amp loudspeaker system for example stage monitor system

Power Requirement1 x Neutrik® 20A powerCON connector 1 x 16A 240 VAC Circuit. Power range 185V-230VAC

System Cooling - High CFM 80mm fan with proportional signal speed control. Rear to front airflow

Dimensions - 88mm Height x 483mm Width x 510mm Depth. Includes rear rack support. 19" rack mount enclosure

Weight - 9 kg